Kreg KMA3700 Accu-Cut XL - Universal Track Saw Guide System - Make Straight, Cross, Rip & Angled Cuts Easily

Holy cow! If you don’t have the money for a table saw for large pieces of wood to cut this is a must! We did a huge project that required cutting multiple sheets of breadboard and plywood. This worked like a charm. Granted we are not professionals however, I’m pretty sure this kept our marriage together during this project!😁

Followed the instructions for assembly and it cuts a straight line without having to clamp it to the piece of wood. Saves a lot of time marking and clamping a piece of wood to the plywood to ensure a straight line.

Great tool, but as others have mentioned, there is a fair amount of play. By the time I used it, I’d forgotten about this, and cut too much of a bevel on my door. Either put downward or leftward pressure to keep the saw from dipping to the right. Other than this, it worked great. I was surprised how well the grippy strips held the track in place. No need for track clamps.

Should have bought a long time ago. Works perfectly with my cordless dewalt saw

I am not a carpenter. I don't make things to sell, so I have no basis to judge this in terms of a professional. But for someone who can't rip straight with a circular saw, and is slightly afraid of a table saw, this was the perfect solution. I needed to rip several 4x8 sheets of plywood into 3" strips. This was the exact right set up.Instructions are good. Easy to follow. My amateur Ryobi circular saw fit into the guide and off we went. Very pleased with this purchase

Awesome. Works as advertised and is much better than the old straight edge I had. Pretty easy to put together and works just like on the videos

Supper easy to use. Must have 7 1/2” blade to cut counter tops since the toboggan pushes you up 3/8ths. Tacky pad runs entire length of the aluminum guide. I recommend clamping each end, and adding a few pieces of green tape to provide positive hold. Especially with hardwoods, Maple Butcher block. Keep the trackpad cleaned with Windex and you will have straight cuts.

Very cheap and flimsy. Doesnt cut accurately.The track is made from aluminum which is great, very straight and accurate. But kreg uses cheap blue plastic pieces in a lot of their jigs which are inappropriate for woodworking. In this case, the sled is plastic. And the set screws bend the plastic sled if they're tightened enough to hold the saw in place. The result is that the saw blade doesnt stay in the exact same spot, even between cuts.This jig relies on blue strips of plastic to achieve zero clearance surface protection for making clean cuts, and for ease of lining it up with your mark. But one the saw has slid out of place due to the cheap plastic material the sled is made out of, the saw eats away the plastic zero clearance strip and the jig is no longer zero clearance. I was very careful to try avoiding this, but clearly not careful enough, and the jig already requires replacement strips after 20 cuts. I feel like this sled will break very easily at some point as well.Kreg needs to make the sled out of aluminum if they want to develop a reputation for quality American made tools.